Whalen SPLS-PE48D Manual De Instrucciones página 22

Q
Ball bearing cart
35. Place the assembled Upper and Lower Drawers back into the box respectively. Extend the Ball Bearing
Slide Tracks on the unit all the way forward (including ball bearing cart). Then align the Slide Runners
on the assembled drawers with the Slide Tracks and push the drawer carefully inside until it stops.
NOTE: If the drawer does not go in smoothly, please take it out and repeat the step. If you need to
remove the drawer, please pull the drawer all the way out, then simultaneously pushes the plastic release
lever of the ball bearing slides up on one side and down on the other side, and then pull it completely out.
Assembly Instructions
A
FRONT
Drawer Installation
22
G
M
FRONT
Ball bearing cart