Dmx Addressing; Programming Scenes - TECshow NAVIGATOR 3 Manual De Usuario

4. DMX ADDRESSING

Addressing Fixtures
In order to have individual control of each fixture
with the Navigator 3, the fixture DMX addresses
should be addressed as follows.
Fixture Button # 1 starts at 1
Fixture Button # 2 starts at 17
Fixture Button # 3 starts at 33
Fixture Button # 4 starts at 49
Fixture Button # 5 starts at 65
Fixture Button # 6 starts at 81
Fixture Button # 7 starts at 97
Fixture Button # 8 starts at 113
Fixture Button # 9 starts at 129
Fixture Button # 10 starts at 145
Fixture Button # 11 starts at 161
Fixture Button # 12 starts at 177

5. PROGRAMMING SCENES

1. PRESS AND HOLD PROGRAM BUTTON (6) for
three seconds to activate program mode. The
LCD DISPLAY (3) will indicate in rogram ode by
displaying a continuous fast blinking light next
to PROG.
2. Select a fixture to program by pressing any or
all FIXTURE BUTTONS 1 TO 12 (1).
3. Adjust the faders to the desired settings (i.e.
Color, bo, Pan, Tilt, Speed, etc.), by adjusting
the fader values. Use the PAGE A B BUTTON
(14) if ur ixture has more than eight channels.
When s from Page A to B you have to ve ders to
activate channels.
4. Once desired setting , press the FIXTURE BUT-
TON (1) to stop adjustment of th fixture. Press
another FIXTURE BUTTON (1) to select another
P. 6
Tecshow Navigator 3 | English version
fixture to adjust. Make adjustments to multiple
fixtures at the same time by selecting multiple
FIXTURE BUTTONS (1) at a time.
5. Repeat steps 2 and 3 until all the fixture set-
tings are complete.
6. When entire scene is set, press and release the
MIDI/REC BUTTON (7).
7. Press a SCENE BUTTON 1-8 (2) to store this
scene. ALL LEDS BLINK 3 TIMES and the LCD
will display the bank and scene where scene
was stored.
8. Repeat steps 2-8 to record first 8 scenes. You
can copy the settings from one fixture button
to another in case you want to add more lights
to your show. Just press and hold the fixture
button you want to copy then press the fixture