User Maintenance; Care And Servicing Of Your Andis Trimmer Blades - Andis LS3 Instrucciones De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS
To reduce the risk of electric shock, this appliance has a polarized plug (one blade
is wider than the other). This plug will fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. Do not change the plug in any way.
Before starting trimmer remove blade guard (some models may not have a blade
guard). Plug cord into electrical outlet, operate at 120 volt, 60 cycle AC electrical
current or as noted on the unit. To start trimmer, move ON/OFF switch button to ON
position, to stop, move switch button back to original position. After using your Andis
trimmer, rewrap cord loosely and store in a safe place.

USER MAINTENANCE

The internal mechanism of your trimmer has been permanently lubricated by the
factory. Other than the recommended maintenance described in this manual, no
other maintenance should be performed, except by Andis Company, or an Andis
authorized service station. To contact Andis directly, please call our Customer
Support Team at 1-800-558-9441 or email us at support@andisco.com.

CARE AND SERVICING OF YOUR ANDIS TRIMMER BLADES

Blades should be oiled before, during, and after each use. If your trimmer blades
leave streaks or slow down, it's a sure sign blades need oil. The trimmer should be
held in the position shown in Figure A to prevent oil from getting into the motor.
Place a few drops of Andis Clipper Oil on the front and side of the cutter blades
(Figure B). Wipe excess oil off blades with a soft dry cloth. Spray lubricants contain
insufficient oil for good lubrication, but are an excellent clipper blade coolant. Always
replace broken or nicked blades to prevent injury. You can clean the excess hair from
your blades by using a small brush or worn out toothbrush. To clean the blades we
suggest to immerse the blades only into a shallow pan of Andis Blade Care Plus,
4
A
B
OIL

Publicidad

Tabla de contenido
loading

Tabla de contenido