User Maintenance - Andis MTC Instrucciones De Uso Y Cuidado

The clipper has not been charged at the factory. Please charge the clipper for
90 minutes before FIRST use for maximum performance. When battery is fully
charged, clipper can be used for up to 120 minutes of continuous run time.
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an appliance you
know is working).
2. Make sure ON/OFF switch on the clipper is OFF.
3. Check to make sure adapter cord is plugged firmly into clipper.
4. If failure to charge still exists, return clipper to Andis or an Andis authorized service
station for examination and repair or replacement.
CORDED OPERATION
If the clipper powers OFF in the middle of a clipping job, the adapter cord can be
attached to continue use in corded operation. When the clipper is running with the
adapter cord attached, the blue light will remain ON. The clipper will not charge
while in use with the cord attached. After using your Andis clipper, rewrap cord
loosely and store in a safe place.
To start clipper, move power switch to ON position. To stop clipper, move power
switch back to original position (Figure B).
CHARGING INDICATOR LIGHT
When the clipper is running, a blue charging indicator light means the battery
has a strong charge (Figure C). When the light turns red, the battery may not hold
enough charge to complete a large clipping job, and should be recharged as soon as
possible. If the clipper powers OFF, move the power switch to the OFF position and
plug the adapter cord directly in the receptacle on the bottom of the clipper (Figure A).
Automatically powering off protects the lithium-ion battery and is not a malfunction.
The clipper will resume normal operation when it is recharged.

USER MAINTENANCE

The internal mechanism of your motor clipper has been permanently lubricated by
the factory. Other than the recommended maintenance described in this manual,
no other maintenance should be performed, except by Andis Company, or an Andis
6