User Maintenance - Andis MHT-1 Instrucciones De Uso Y Cuidado

CORDED OPERATION
If the trimmer powers OFF in the middle of a trimming job,
the charging adapter can be attached directly to the bottom
of trimmer to continue use in corded operation.
USING ATTACHMENTS
(Figure 1)
SQUARE BLADE
For removing bulk hair. Use for trimming beard, mustache
and sideburns. Can be used with or without trimmer comb,
depending on the desired cutting length.
T-BLADE
Ideal for outlining and making tight lines.
PRECISION BLADE
Use for hair designs and detailing in tight spaces. Can be used
with or without trimmer comb, depending on the desired
cutting length.
NOSE/EAR TRIMMER
For trimming hair from the nose and ears. Clear nasal
passages before you begin. Slowly move tip in and out of the
nostril to remove excess hair. For best results, make sure the
side of the tip is firm against skin. This will reduce the tickling
effect that can occur. Caution: Do not insert tip more than
1/4" into nostril.
CHANGING ATTACHMENTS
Press down the blade attachment switch and place the
attachment on trimmer until it snaps into place. Release the
blade attachment switch (Figure 2). To remove the attachment,
press down the blade attachment switch and pull attachment
off the trimmer.
ATTACHING THE TRIMMER COMB
The trimmer comb fits over Square and Precision blades only.
To attach the trimmer comb, simply slide the blade into the
base of the comb until it snaps into place (Figure 3). The
comb can be snapped into one of 6 cutting lengths. To
remove the comb, simply push forward at its base until it snaps off.

USER MAINTENANCE

The internal mechanism of your trimmer has been permanently lubricated at the
factory. Other than the recommended maintenance described in this manual, no other
maintenance should be performed, except by Andis Company or an Andis Authorized
Service Station. Contact our customer service department: 1-800-558-9441 (U.S.)
or 1-800-335-4093 (Canada).
6
CLEANING
All manuals and user guides at all-guides.com
1
Disconnect the trimmer from the charging adapter (if being used) and allow it to cool
before cleaning. Remove attachment from the trimmer. Use the cleaning brush to
remove hair from the inside of the trimmer and attachments. For a more thorough
cleaning, clean attachment with damp cloth and mild dishwashing detergent, run
under water, then dry. Do not use solvents or products with an acid or base pH such
as bleach, or abrasive products, for cleaning the trimmer. Never submerge the
trimmer in water or any other liquid or place it under running water. During
cleaning, be careful, as the blades are very sharp.
PROPER BATTERY DISPOSAL
Batteries may contain heavy metals such as mercury, lead, cadmium, nickel and
lithium, which can be harmful to the environment when improperly disposed of.
Remove dead batteries from the trimmer and dispose of properly. Some communities
offer recycling or collection of batteries – contact your local government for disposal
practices in your area.
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with other
household wastes. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote
2
the sustainable reuse of material resources. To return your used device,
please use the return and collection systems or contact the retailer where the
product was purchased. They can take this product for environmental safe recycling.
3
7