Kobalt KHD 124B-03 Manual De Instrucciones página 12

OPERATING INSTRUCTIONS
8. Adjustable Torque Clutch
The torque adjustment ring (B) can be set any of 24
torque settings when the tool is in the driving mode
.
Adjust the torque by rotating the torque adjustment
ring (B). The higher the torque setting number, the
more force the hammer drill produces to turn an
object.
The proper setting depends on the job and the type
of bit, fastener, and material you will be using. In
general, use greater torque for larger screws. If the
torque is too high, the screws may be damaged or
broken.
Torque adjustment is not available for the drilling or
hammer mode.
NOTICE: Do not change the torque setting when the tool is running.
9. Installing and Removing the Belt Clip
a. Align the rib of the belt clip (I) with the hole on
the base of the hammer drill.
b. Insert the screw and tighten the screw securely
with a Phillips-head screwdriver (not included).
c. To remove the belt clip, use a Phillips-head
screwdriver to loosen the screw holding the
belt clip to the hammer rill.
NOTE: The belt clip can be installed on the right or
left side of the tool.
10. Installing and Removing the Bit Holder
a. Align the rib of the bit holder (J) with the hole
on the base of the hammer drill.
b. Insert the screw and tighten the screw securely
with a Phillips-head screwdriver (not included).
c. To remove the bit holder, use a Phillips-head
screwdriver to loosen the screw holding the bit
holder to the hammer drill.
NOTE: The bit holder can be installed on the right
or left side of the tool.
8
9
10
J
Screw
12
B
I
Screw