Troubleshooting; Corrective Action; Warranty - Kobalt KHD 124B-03 Manual De Instrucciones

TROUBLESHOOTING

WARNING
Place the direction-of-rotation selector (E) in the center lock position and detach the battery
pack from the hammer drill before performing troubleshooting procedures.
PROBLEM
The hammer drill
does not work.
Bit cannot be
installed.
Motor overheating.
The LED work light
flashes rapidly.
The LED work light
flashes slowly.

WARRANTY

For 5 years from the date of purchase, the power tool is warranted and for 3 years from date of
purchase the battery & charger are warranted for the original purchaser to be free from defects
in material and workmanship. This guarantee does not cover damage due to abuse, normal
wear, improper maintenance, neglect, unauthorized repair/alteration, or expendable parts and
accessories expected to become unusable after a reasonable period of use.
If you think your product meets the above guarantee criteria, please return it to the place of
purchase with valid proof of purchase and the defective product will be repaired or replaced at
no charge. This guarantee gives you specific legal rights, and you may also have other rights
that vary from state to state.
POSSIBLE CAUSE
Battery pack is depleted.
Chuck is not released.
Bit does not fit the
chuck.
Ventilation slots are
obstructed.
The tool has stopped
working to protect
internal circuits.
The battery pack charge
is very low.
Lowe's Home Centers LLC. MOORESVILLE, NC 28117

CORRECTIVE ACTION

Charge the battery pack.
Release the chuck.
Use an appropriate bit or use a suitable
adaptor.
Clean and clear the ventilation slots. Do
not cover ventilation slots with hand during
operation.
Release the trigger switch, wait for the tool
to cool down, then and start the tool again.
Charge the battery pack.
18
Printed in China