Removing The Apparatus; Cleaning And Disinfecting - INTERSPIRO INCURVE-E Manual De Usuario

After the pre-alarm, the unit enters alarm mode.
When activated, the unit may be put into alarm mode at any time by pressing the
panic button.
In alarm mode the BAC emits a loud audible signal, the yellow and red LED on the
Digital Display will alternate, the backlight of the display flashes yellow and red and
the main LED on the BAC flashes red.
INTERNAL EVACUATION SIGNAL
This function is configuration dependent and only available on the version with the
tally key. To activate, press and hold the backlight button and then press the panic
button.
The signal is the same as the alarm mode described above, but with a different
intermittent warning sound.
10

REMOVING THE APPARATUS

Switch off the positive pressure.
1.
Open the buckles to release the head harness, loosen the strap and remove the
2.
face mask.
Close the cylinder valve.
3.
NOTE: TO PREVENT UNINTENTIONAL CLOSING OF THE CYLINDER VALVE, THE HAND WHEEL MUST BE PUSHED IN BEFORE
IT CAN BE TURNED.
If applicable unfasten the chest buckle.
4.
Unfasten the waist belt buckle and loosen the shoulder straps.
5.
Remove the apparatus and activate the positive pressure to purge air from the
6.
system. Deactivate the Automatic Distress Signal Unit as described in section 9.
Disconnect the HUD (if fitted) according section 3.
7.
11

CLEANING AND DISINFECTING

Disconnect the breathing valve from the face mask. Do not disconnect the
1.
breathing hose from the breathing valve.
Mount a wash plug on the breathing valve and on the whistle.
2.
When washing the cylinder if applicable use wash plug 32350-51 on the cylinder
3.
valve pressure gauge.
Open the cylinder valve and check that there is pressure in the system before
4.
cleaning.
NOTE: HAVING THE CYLINDER VALVE OPEN PREVENTS WATER FROM ENTERING THE SYSTEM AND BUBBLES WILL
INDICATE ANY LEAKS IN THE SYSTEM.
Spray on or submerge the breathing apparatus in water and cleaning solvent. Use
5.
cleaning solvent recommended by Interspiro, max 55°C.
Clean the apparatus with a sponge or brush.
6.
22