Storage And Transport - INTERSPIRO INCURVE-E Manual De Usuario

REPLACING BAC BATTERY
ATTENTION! BATTERIES MUST ONLY BE CHANGED IN AN AREA KNOWN TO BE NON-HAZARDOUS.
ATTENTION! DOWNLOAD THE USER LOG PRIOR TO REPLACING THE BATTERIES. AFTER REPLACING BATTERIES, CHECK
THE DATE AND TIME SETTING OF THE UNIT AND RE-SET IF NECESSARY. IF THE CURRENT IS BROKEN FOR MORE THAN 1.5
MINUTES, DATE AND CLOCK SETTINGS IN THE BAC WILL BE LOST AND EVENTS WILL NOT BE LOGGED CORRECTLY.
Remove the two screws on the battery cover with a cross-slotted (Phillips)
1.
screwdriver. [Fig. 16:a]
Remove the battery cover. Next remove the battery pack by lifting the handle. [Fig. 16:b]
2.
Insert three new AAA batteries in the direction of the markings on the inside of the
3.
battery pack. [Fig. 17]
Reassemble the battery pack and insert into the BAC. Orientate the battery pack
4.
according to the markings inside the BAC and on the sides of the battery pack.
If the battery pack is correctly positioned, the BAC beeps when connected to the batteries.
Replace the battery cover and gently tighten for even gasket pressure, ensuring a
5.
good seal. Do not over-tighten the screws.
REPLACING WIRELESS HUD BATTERIES
Remove the HUD from the face mask. Refer to section 3.
1.
Using a Phillips screwdriver, unscrew the battery cover screw. [Fig. 18]
2.
Lift up the locking tab and open the battery compartment cover. [Fig. 18]
3.
Insert a AAA battery in the direction of the marking on the HUD. [Fig. 18]
4.
Close the cover and reassemble the cover with the screw. Gently tighten for even
5.
gasket pressure ensuring a good seal. Do not over-tighten.
Repeat the same procedure for the second battery on the other side.
6.
When the batteries are installed, the HUD will flash all six LEDs five times.
14

STORAGE AND TRANSPORT

Store in a cool, dry and dust-free environment. Protect rubber parts from direct
sunlight, UV radiation and direct heat. When the regulator unit is not connected, the
cylinder valve should always have a protective plug.
The unit should be stored with the face mask/breathing valve in the position for
activated positive pressure.
During transport the product must be well protected inside the original packaging
material or equivalent packaging material.
24