To Lubricate The Belt Adjuster; To Do A Check Of The Transmission Oil Level; Troubleshooting; Troubleshooting Schedule - Husqvarna R 214T Manual De Usuario

12. Turn the oil filter clockwise by hand until the rubber
seal is in position, then tighten the oil filter a half turn
more.
13. Fill the oil slowly through the hole for the dipstick.
Use an oil with viscosity that agrees with the
temperature ranges in the figure. Refer to
data on page 31 .
-20°C -10°C 0°C
SAE10W-30
SAE5W-20
-4°F -14°F 32°F
14. Start the engine and let it operate at idle speed for 3
minutes.
15. Stop the engine and make sure that there are no
leaks.
16. Fill with oil to make up for the oil held in the new oil
filter.
To do a check of the transmission oil
level
Note:
Do the transmission oil check when the
transmission is cool.
1. Put the product on a horizontal surface.
2. Remove the screws, one on each side, and remove
the transmission cover.

Troubleshooting schedule

If you cannot find a solution to your problems in
this owner's manual, speak to your Husqvarna service
agent.
1686 - 002 - 16.12.2021
Technical
10°C 20°C 30°C 40°C
SAE40
SAE30
SAE10W-40
50°F 68°F 86°F 104°F

Troubleshooting

3. Make sure that the oil level in the transmission oil
tank is between the 2 horizontal lines on the tank.
4. Fill with oil if the oil level is below the lower line, but
do not fill above the top line. Refer to
on page 31 for recommended oil.

To lubricate the belt adjuster

The belt adjuster must be lubricated regularly with a
good quality molybdenum disulphide grease.
1. Remove the 2 screws that hold the belt shield and lift
it off.
2. Lubricate with a grease gun through the nipple at the
right side, below the lower belt pulley. Lubricate until
grease is pushed out of the rear side of the nipple.
3. Attach the belt shield and tighten the 2 screws.
Max
Min
Technical data
27