To Lubricate The Links And Joints In The Cutting Height Adjustment; To Lubricate The Seat Slides; To Lubricate The Hydrostatic Transmission Cable; To Lubricate The Throttle Cable, Choke Cable And Lever Bearings - Husqvarna R 418Ts AWD Manual De Usuario

To lubricate the links and joints in the
cutting height adjustment
1. Lubricate the links and the joints for the cutting
height adjustment, behind the right front wheel.
Lubricate with oil.

To lubricate the seat slides

1. Tilt the seat forward.
2. Lubricate the seat slides with engine oil.
To lubricate the throttle cable, choke
cable and lever bearings
1. Remove the right side cover.
2. Open the engine cover.
3. Lubricate the free ends of the cables, including the
ends near the engine, with engine oil.
4. Move the throttle control, choke control and the
controls for the cutting deck to their end positions
and lubricate the cables again.
522 - 002 -
5. Lubricate the joints, catches and bearings of the
controls for the cutting deck with engine oil.
6. Attach the right side cover.
To lubricate the hydrostatic
transmission cable
1. Remove the two screws, one on each side, and
remove the transmission cover.
2. Lubricate the joints and bearings on the left side with
engine oil.
3. Remove the rubber sleeve and lubricate the
hydrostatic transmission cable with engine oil.
4. Press the forward drive pedal 5 times and lubricate
the hydrostatic transmission cable again.
5. Attach the rubber sleeve.

To lubricate the belt adjuster

The belt adjuster must be lubricated regularly with a
good quality molybdenum disulphide grease.
31