Premixed Fuel - Husqvarna 128PS Manual De Usuario

CAUTION:
result in engine damage. Use a mixture
of gasoline and two-stroke oil.

Premixed fuel

• Use Husqvarna premixed alkylate fuel for
best performance and extension of the engine
life. This fuel contains less harmful chemicals
compared to regular fuel, which decreases
harmful exhaust fumes. The quantity of remains
after combustion is lower with this fuel, which
keeps the components of the engine more clean.
To mix fuel
Gasoline
CAUTION:
an octane number less than 90 RON
(87 AKI). This can cause damage to the
product.
CAUTION:
more than 10% ethanol concentration
(E10). This can cause damage to the
product.
CAUTION:
gasoline. This can cause damage to the
product.
• Always use new unleaded gasoline with a
minimum octane number of 90 RON (87 AKI)
and with less than 10% ethanol concentration
(E10).
• Use gasoline with a higher octane number if you
frequently use the product at continuously high
engine speed.
• Always use a good quality unleaded gasoline/oil
mixture.
Two-stroke oil
• For best results and performance use Husqvarna
two-stroke oil.
• If Husqvarna two-stroke oil is not available, use
a two-stroke oil of good quality for air-cooled
engines. Speak to your servicing dealer to select
the correct oil.
CAUTION:
stroke oil for water-cooled outboard
engines, also referred to as outboard
oil. Do not use oil for four-stroke
engines.
12
Incorrect type of fuel can
Do not use gasoline with
Do not use gasoline with
Do not use leaded
Do not use two-
To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
CAUTION:
influence the ratio of the mixture
drastically when you mix small quantities
of fuel. Measure the quantity of oil
carefully and make sure that you get the
correct mixture.
1. Fill half the quantity of gasoline in a clean
container for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION:
than 1 month at a time.
To fill the fuel tank
1. Clean the area around the fuel tank cap.
2. Shake the container and make sure that the fuel
is fully mixed. Use a fuel container with an anti-
spill valve.
3. Fill the fuel tank.
4. Tighten the fuel tank cap carefully.
5. Move the product 3 m (10 ft) or more away from
the refueling area and fuel source before starting.
Two-stroke
oil, liter
2% (50:1)
0.10
0.20
0.30
0.40
Small errors can
Do not mix fuel for more
1780 - 002 - 20.04.2022