To Adjust The Harness; Operation; To Check Before Starting - Husqvarna 128PS Manual De Usuario

7. Turn the knobs on the extension shaft and the
engine shaft clockwise and tighten them.
8. Tighten the couplers on the extension shaft and
the engine shaft.

To adjust the harness

You should always use the harness with the
machine to give maximum control over the machine
and reduce the risk of fatigue in your arms and back.
1. Put on the harness.
2. Hook the machine onto the harness support
hook.
3. Adjust the length of the harness so that the
support hook is roughly level with your right hip.
Introduction
WARNING:
product, you must read and understand
the safety chapter.

To check before starting

1. Inspect the working area. Remove any objects
that could be thrown out.
2. Check the saw chain. Never use blunt, cracked
or damaged equipment.
3. Check that the product is in perfect working
order.
4. Check that all nuts and screws are tight.
1780 - 002 - 20.04.2022

Operation

Before you operate the
To disassemble the two-piece shaft
1. Turn the knob to loosen the shaft coupling.
2. Push and hold the locking/release button (B).
Pull the shafts apart.
5. Make sure the chain is adequately lubricated,
To check the chain lubrication on page
refer to
20 .
6. Check that the saw chain always stops when the
engine is idling.
7. Only use the product for the purpose it was
intended for.
8. Make sure the handle and safety features are in
order. Never use a machine that has any parts
missing or has been modified in relation to the
specification.
Fuel
This product has a two-stroke engine.
11