Safety Devices On The Product - Husqvarna 128PS Manual De Usuario

accident does occur. Let your dealer help you
select the right equipment.
• Use a protective helmet where there is a risk of
falling objects.
• Use approved hearing protection that provides
adequate noise reduction. Long-term exposure
to noise can result in permanent hearing
impairment.
• Use approved eye protection. If you use a visor,
you must also use approved protective goggles.
Approved protective goggles must comply with
the ANSI Z87.1 standard in the USA or EN 166
in EU countries.
• Use a visor for face protection. A visor is not
enough for protection of the eyes.
• Use gloves when necessary, for example when
you attach, examine or clean the cutting
equipment.
• Use sturdy non-slip boots.
• Use clothing made of a strong fabric. Always
use heavy, long pants and long sleeves. Do
not use loose clothing that can catch on twigs
and branches. Do not wear jewelry, short pants,
sandals or go with bare feet. Put your hair up
safely above shoulder level.
• Keep first aid equipment close at hand.

Safety devices on the product

WARNING:
instructions that follow before you use
the product.
• Do not use a product with defective safety
devices.
• Do a check of the safety devices regularly. Refer
Maintenance schedule on page 15 .
to
• If the safety devices are defective, speak to your
Husqvarna servicing dealer.
1780 - 002 - 20.04.2022
+
Read the warning
To do a check of the throttle trigger lockout
1. Make sure that the throttle trigger lockout (A) and
throttle trigger (B) move freely and that the return
spring works correctly.
B
2. Push down the throttle trigger lockout and make
sure that it goes back to its initial position when
you release it.
3. Make sure that the throttle trigger is locked at the
idle position when the throttle trigger lockout is
released.
4. Start the product and apply full throttle.
5. Release the throttle trigger and make sure that
the saw chain stops and stay stationary.
WARNING:
moves when the throttle trigger is in
the idle position, then the carburetor
idle speed must be adjusted. Refer
To adjust the idle speed on page
to
21 .
To do a check of the stop switch
1. Start the engine.
A
If the saw chain
7