To Stop The Product; Maintenance; Maintenance Schedule - Husqvarna 128PS Manual De Usuario

To start the engine when the fuel is
too hot
If the product does not start, the fuel can be too hot.
Note:
Always use new fuel and decrease the
operation time during warm weather.
1. Put the product in a cool area away from open
sunlight.
2. Let the product cool down for 20 minutes at
minimum.
3. Press the air purge bulb again and again for
10-15 seconds.
4. Obey the procedure to start a cold engine. Refer
To start a cold engine on page 14 .
to

To stop the product

• Push the stop switch to stop the engine.
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.

Maintenance schedule

The following is a list of the maintenance steps that
must be performed on the product. Most of the items
are described later in this chapter.

Maintenance

Clean the external surface.
Examine the harness for damages.
Do a check for damages on the suspension ring.
Make sure that the throttle trigger lock and the throttle works correctly.
Do a check of the stop switch to make sure that it works correctly.
Make sure that the saw chain does not rotate at idle speed.
Clean the air filter. Replace if necessary.
1780 - 002 - 20.04.2022
Note:
The stop switch automatically goes back to
its initial position.
About the surface
Maintenance
Note:
The user must only carry out the
maintenance and service work described in this
operator's manual. More extensive work must be
carried out by an authorized service workshop.
WARNING:
Do not put parts of your
body in the grey marked area. If you
touch the grey marked area it can result
in burns to the skin. It can also cause
electrical shock if the spark plug cap has
been damaged. Do not use a product
with a damaged spark plug cap.
Daily Weekly
X
X
X
X
X
X
X
Monthly
15