Electrical Connection; Adjusting The Legs; Hot Surface Warning - Beko B5RCNE365HXB Manual Del Usuario

WARNING:
The manufacturer assumes no re-
sponsibility for any damages
caused by the work carried out by
unauthorized persons.
WARNING:
The product's power cable must be
unplugged during installation. Fail-
ure to do so may result in death or
serious injuries!
WARNING:
If the door span is too narrow for
the product to pass, remove the
door and turn the product side-
ways; if this does not work, contact
the authorized service.
• Place the product on a flat surface to
avoid vibration.
• Place the product at least 30 cm away
from the heater, stove and similar
sources of heat and at least 5 cm away
from electric ovens.
• Do not expose the product to direct sun-
light or keep it in damp environments.
• Your product requires adequate air circu-
lation to function efficiently. If the product
will be placed in an alcove, remember to
leave at least 5 cm clearance between
the product and the ceiling, rear wall and
the side walls.
• Check if the rear wall clearance protec-
tion component is present at its location
(if provided with the product).
• If the component is not available, or if it is
lost or fallen, position the product so that
at least 5 cm clearance shall be left
between the rear surface of the product
and the wall of the room. The clearance
at the rear is important for efficient opera-
tion of the product.

4.2 Electrical Connection

Do not use extension or multi sock-
ets in power connection.
Damaged power cable must be re-
placed by Authorized Service.
When placing two coolers in adja-
cent position, leave at least 4 cm
distance between the two units.
• Our firm will not assume responsibility for
any damages due to usage without earth-
ing and power connection in compliance
with national regulations.
• The power cable plug must be easily ac-
cessible after installation.
• Do not use multi-group plug with or
without extension cable between the wall
socket and the refrigerator.

4.3 Adjusting the Legs

If the product is not in balanced position,
adjust the front adjustable legs by rotating
them to right or left.

4.4 Hot Surface Warning

The side walls of your product are
equipped with cooler pipes to enhance the
cooling system. High pressure fluid may
flow through these surfaces, and cause hot
surfaces on the side walls. This is normal
and it does not require servicing. Be careful
when you contact these areas.
EN / 13
EN
FR
PT
ES