Installation Procedures; Installing The Sensor - Garmin GRF 10 Instrucciones De Instalación

Ocultar thumbs Ver también para GRF 10:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25
Connection Considerations
• This sensor can be connected to a compatible Garmin
connector.
• The cable connected to the sensor is 78 in. (2 m) long.
◦ If needed, extension cables for the sensor are available from your Garmin dealer.
◦ Do not cut the sensor cable to extend or shorten it.

Installation Procedures

Installing the Sensor

For the best results, keep the rudder amidships during the sensor-installation process.
1 Rotate the sensor counter-clockwise so the arrows on the back
2 Place the sensor at the selected mounting location, and mark the center of the three mounting holes.
3 Place the tiller-arm mount on the tiller arm at the mounting location, and mark the center of the two
mounting holes.
1
4 Using a 3.2 mm (
/
in.) bit, drill three pilot holes in the mounting surface for the sensor, and two pilot holes
8
in the tiller arm for the tiller-arm mount.
5 Fasten one of the ball-joint assemblies to the tiller-arm mount using the included M6 locknut.
6 Place the other ball-joint assembly into the appropriate hole on the sensor (typically the second hole from the
tip), and fasten it with the included washer and locknut using a 10 mm socket.
4
autopilot system with a 12-pin rudder feedback
®
line up in the center
.
Installation Instructions

Publicidad

Tabla de contenido
loading

Tabla de contenido