Makita UC002G Manual De Instrucciones página 15

4.
Check the direction of the saw chain. Match
the direction of the saw chain with that of the
mark on the chain saw body.
1
Fig.11
► 1. Mark on chain saw body
5. Fit one end of the saw chain on the top of
the guide bar.
6. Fit the other end of the saw chain around
the sprocket, then attach the guide bar to the
chain saw body, aligning the hole on the guide
bar with the pin on the chain saw body.
1
Fig.12
► 1. Sprocket 2. Hole
7.
Insert the protrusion and the pin on the
sprocket cover to the chain saw body, and then
close the cover so that the bolt and pin on the
chain saw body meet their counterparts on the
cover.
1
4
4
Fig.13
► 1. Protrusion 2. Sprocket cover 3. Bolt 4. Pin
8. Tighten the retaining nut to secure the
sprocket cover, then loosen it a bit for tension
adjustment.
2
Fig.14
► 1. Retaining nut
After installing the saw chain, adjust the saw
chain tension by referring to the section for
adjusting saw chain tension.
15 ENGLISH
2
3
1