Cleaning And Maintenance - cecotec CUMBIA POWER ESPRESSO 20 MATIC Manual De Instrucciones

ENGLISH
process is over (about 2 minutes). Once the appliance has reached its optimal temperature, the
light will stop flashing.
Press the espresso button. Hot water will come out from the machine, use the water to clean
filters or cups.
3. OPERATION
Making coffee
Place the filter in the filter holder.
While the appliance is preheating, fill the filter with coffee and use the end part of the spoon
to press it down.
Hold the portafilter, introduce the filter holder into the machine and place an empty cup on the
removable grid.
Press the espresso button in order to brew 1 single espresso.
Press the double espresso button in order to brew 1 double espresso.
Note: These 2 previous functions are customizable. If you want to change the preset amount of
drink previously saved, do the following:
Press the single or double espresso button. Once you have obtained the desired amount of
drink, press again the previous button to stop drink from being dispensed. Next time the button
is pressed, the machine will dispense the new saved amount.
Press the manual control button once in order to serve the desired amount of coffee, and press
the same button again to stop it.
Steam and froth function
Note: It is suggested to release some steam before frothing milk.
Press the steam button. The light indicator will turn red and flash. Once the preheating process
is over, the light will stop flashing.
Pour milk into a jug and fill it up to 1/3. Introduce the steam nozzle and slowly turn the steam
dial.
Recommendation: It is recommended to use cold whole milk for optimal results.
Note: The steam tube degree can be adjusted.
Warning: Clean the steam exit with a wet sponge immediately after use. Then, remove the
steam tube and clean the duct's inside part. It is also recommended to emit steam again in
order to clean possible milk remaining inside the tube.
Hot water function
Press the power button, the light indicator will turn blue indicating that the machine is
preheating. Once the light stops flashing, the machine is ready.
Turn the dial to the ON position, hot water will be dispensed. This hot water can be used for
36
cleaning, warming cups, drinking etc.
Turn the dial back to OFF in order to turn the machine off.

4. CLEANING AND MAINTENANCE

Disconnect the power cord from the wall socket before cleaning. Do not immerse the product
in water or any other fluid during cleaning.
Failure to maintain the product in clean conditions could lead to surface deterioration and
could adversely affect the product's shelf life, resulting in possible hazard.
Never use strong detergents, gasoline, abrasive powder or metal brush to clean any part of
the product.
After frothing milk, use a dampened soft cloth to clean the steam tube and the nozzle, and
allow some steam to come out in order to prevent the inside part from blocking due to dry milk.
A complete cleaning cycle is suggested each 3 months. Carry out the following steps:
Fill in the water tank and add anti-scale cleaning product (otherwise use vinegar) and carry out
a whole cleaning cycle in order to clean the machine's inside.
Repeat the before step again only with water to rinse the machine's inside and remove all the
product or vinegar rests.
5. TROUBLESHOOTING
Problem Causes
Coffee does not come out No water in tank.
Coffee grind is too fine.
There is too much coffee in
the filter.
The device is not turned on
or connected to the power
supply.
Coffee has been tamped/
compressed too much.
Coffee comes out around Portafilter not rotated to full
the edge of the portafilter. lock position.
There is ground coffee on the
edge of the filter.
There is too much coffee in
the filter.
ENGLISH
Solutions
Add water.
Grind medium-ground coffee.
Fill filter with less coffee.
Connect the unit to a power
supply and turn it on.
Refill the filter basket with
coffee, do not tamp too much.
Rotate filter holder to full lock
position.
Wipe off the rim.
Fill with less coffee.
POWER ESPRESSO 20 MATIC 37