Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3
Press SELECT on the front panel to start the automatic adjustment of speaker settings with YPAO.
Adjustment starts automatically after about 10 seconds. It takes about 1 minutes.
Do not make any unnecessary noise until the adjustments are complete.
RIGHT
-50 -40 -30
-20
-10
-0
+6
PURE DIRECT
WER
0.01
0.1
1
10 100
W/8
dB
LANCE
LOUDNESS
SELECT
PUSH - ENTER
PRESET
FLAT
-30dB
RETURN
CONNECT
R
4
Check the results on the front display.
After all adjustments are complete, the results are shown on the front display. Follow the instructions that are
displayed, and use the SELECT buttons to complete adjustments.
If there are no errors or warnings:
If an error message or warning message appears on the
display, refer to the User Guide.
"E-" means error.
5
Save the YPAO results.
Check the following display, and press SELECT to save the adjustment results.
To cancel or readjust (Retry), turn SELECT to choose the desired item.
6
Remove the YPAO microphone from the YPAO MIC jack.
After checking the following display, disconnect the YPAO microphone.
This completes the YPAO settings.
VOLUME
SELECT
PUSH - ENTER
This prompts you to press SELECT to go to the next step.
"W-" means warning.
User Guide
https://manual.yamaha.com/av/21/rn2000a/q1ypao.html/
9
Publicidad
Tabla de contenido
