Recycling + Disposal; Service + Support - sunjoe 24V-HCSWP-CT Manual Del Operador

6. Depth gauges are small teeth on the cutter which protrude
in front of the cutting edge. In order for the chain to cut
effectively, the depth gauge must be lower than the cutting
edge. Therefore, after heavy use or multiple sharpenings
the depth gauge may require filing down.
Place the depth gauge tool over the chain. Ensure that a
depth gauge is exposed and protruding from the slot on
the tool. Using the flat file, file down the depth gauge until
flush with the tool in a forward motion (Fig. 34).
Fig. 34
File forward
Depth gauge tool
Cutting edge
Depth gauge tool
7. Remove the depth gauge tool and round off the edge of
the depth gauge with your file.
8. Repeat for all cutters on both sides of the chain.
9. After sharpening, clean the saw of any metal filings or
dust, then tighten (Fig. 13) and lubricate the chain
(Fig. 16).
Battery Caution + Disposal
Always dispose of your battery pack according to federal,
state, and local regulations. Contact a recycling agency in your
area for recycling locations.
m
CAUTION!
Even discharged battery packs contain
Flat file
Depth gauge
Flat file
Amount to
file down
Depth gauge
some energy. Before disposing, use electrical tape to cover
the terminals to prevent the battery pack from shorting, which
could cause a fire or explosion.
m
WARNING!
To reduce the risk of injury or explosion,
never burn or incinerate a battery pack even if it is damaged,
dead, or completely discharged. When burned, toxic fumes
and materials are emitted into the surrounding environment.
• Batteries vary according to device. Consult your manual
for specific information.
• Install only new batteries of the same type in your product
(where applicable).
• Failure to insert batteries in the correct polarity, as
indicated in the battery compartment or manual, may
shorten the life of the batteries or cause batteries to leak.
• Do not mix old and new batteries.
• Do not mix Alkaline, Standard (Carbon-Zinc), or
Rechargeable (Nickel Cadmium, Nickel Metal Hydride, or
Lithium-Ion) batteries.
• Do not dispose of batteries in fire.
• Batteries should be recycled or disposed of as per state
and local guidelines.

Recycling + Disposal

The product comes in a package that protects it against
damage during shipping. Keep the package until you are
sure that all parts have been delivered and the product is
functioning properly. Recycle the package afterwards or keep
it for long-term storage.
WEEE symbol. Waste electrical products should not
be disposed of with household waste. Please
recycle where facilities exist. Check with your local
authority or local store for recycling regulations.

Service + Support

If your Sun Joe 24V-HCSWP-CT cordless pruning saw
®
requires service or maintenance, please call 1-866-SNOWJOE
(1-866-766-9563) for assistance.
Model + Serial Numbers
When contacting the company, reordering parts, or arranging
service from an authorized dealer, you will need to provide the
model and serial numbers, which can be found on the decal
located on the housing of the unit. Copy these numbers into
the space provided below.
Record the following numbers from the housing or handle of your
new product:
Model #:
2 4 V - H C S W P - C T
Serial #:
19