Ketra D3 Serie Guia De Instalacion página 18

A D D I T I O N A L O P E R AT I O N S
3. Replacing the optic
a. Remove the trim by pulling the trim directly down from the housing.
b. Ensure that the emitter chassis is locked.
c. Grab optic and twist counterclockwise to unlock. Pull toward you to remove.
d. Install replacement optic, twisting clockwise to lock (see fig. 18).
Note: Demonstrate caution when removing wall wash optic due to possible damage.
Primary Optic Removal
Primary Optic Removal
Note: If you remove the optic, be careful not to touch the exposed silicone dome on the emitter.
Twist to Unlock (Rotation lock should be set)
Twist to Unlock (Rotation lock should be set)
fig. 18
4. Replacing the power supply
a. Remove the trim by pulling the trim directly down from the housing.
b. For all configurations except Wall Wash, tilt the Light Engine to 40˚ and rotate to allow access to the
power supply. For Wall Wash, use the steps shown in Section 3 (above) to remove the optic and access
the power supply.
c. Unhook the emitter cable from the RJ45 jack on the power supply.
d. Pull power supply straight out from the docking station while depressing docking station latch.
e. Disconnect power supply quick connect (see fig. 19).
fig. 19
Tilt locked at 40˚ . Emitter
Module in Full Regress
Unlocked and rotated so
that Emitter Module tilts
away from Power Supply
18 | D3 INSTALLATION GUIDE
Primary Optic Replacement
Primary Optic Replacement
Pull to Remove (Optic is not tethered!)
Pull to Remove (Optic is not tethered!) Align to Shoulder Pins and Insert
Align to Shoulder Pins and Insert
© 2019-2022 Ketra, Inc. All rights reserved.
Twist to Lock
Twist to Lock
Disconnect
power supply
Disconnect
emitter module
P/N 3662708 Rev A