Ketra D3 Serie Guia De Instalacion página 19

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

A D D I T I O N A L O P E R AT I O N S
5.
Installing or replacing the collar adapter
a.
Use a Phillips screwdriver to remove the four collar adapter screws.
b.
Remove collar adapter from the housing.
c.
Place new collar adapter on the housing and align all four screw holes with the threaded holes on
the housing. NOTE: Collar adapter will fit flush to the housing when properly aligned.
d.
Use a Phillips screwdriver to install the four collar adapter screws.
e.
Verify that the collar adapter can rotate easily in the clockwise and counterclockwise direction.
NOTE: Collar adapter must be installed before ceiling installation.
fig. 20
P/N 3662708 Rev A
© 2019-2022 Ketra, Inc. All rights reserved.
Housing
Collar adapter
Collar adapter screws (4)
D3 INSTALLATION GUIDE | 19

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido