Citizen CT-S2000 Manual De Usuario página 18

3.5 Partition for Paper Roll
At the time of shipment, this partition is set to "80-mm
wide roll paper position".
1. Confirm that the power switch is OFF.
2. Open the printer cover.
3. Set the partition to each to the slot which
meets the width of the paper roll used. When
using the 83-mm wide paper roll, remove the
partition.
4. Change the setting of paper width by reffering
to the section 5.2, "Manual Setting of Memory
Switch".
CAUTION!
When setting the partition to the slot for 58 mm or 60 mm paper roll, be sure not to set
it slanted.
3.6 Setting DIP Switch
The DIP switch is present on the serial interface
board.
Remove the board fixing screws, take out the
interface board, and then set the DIP switch. The
function of each switch is as shown below.
CAUTION!
When setting the DIP switch, DO NOT remove screws other than those for mounting
the serial interface board.
Switch No.
1 Communication condition DIP switch setting
setting method
2 Hand shake
3 Bit length
4 Parity check
5 Parity selection
6
Baud rate selection
7
8 INIT
Selecting baud rate
Baud Rate (bps)
2400
4800
9600
19200
1200, 38400, 57600 and 115200 bps can also be selected by a command, etc.
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
Function
XON/XOFF
7 bits
With parity
Even parity
See Table below.
Reset
6
OFF
ON
OFF
ON
V10 CONSUMIBLES S.L.
Interface board
mounting screws
ON
Memory switch
setting
DTR/DSR
8 bits
None
Odd parity
Invalid
Switch No.
— 15 —
60mm
80 58mm
mm
Partition
DIP switch
InitialSettings
OFF
OFF
OFF
OFF
OFF
OFF
ON
ON
OFF
7
OFF
OFF
ON
ON