TEFAL OptiGrill + Instrucciones De Uso página 93

+ Intermittent beeping
The device does not
beep.
The indicator light will blink
white
+ Button blinking
+ Continuous beeping
Cause
• Switching on the • 2 possible
options: appliance or starting –
Choose the temperature setting
by an automatic cooking pressing
the button and then c y c l e w i t
h fo o d press OK. Allow to cook,
but you must and without plates
monitor the cooking (manual
mode). preheating (manual –
After preheating, I placed the food inside • The quantity of food • The quantity of food should not
exceed and closed the appliance, but the inside the appliance is 4 cm.
indicator light stays purple and cooking greater than 4 cm.
does not begin. • The grill was not opened • Open the grill completely and close it completely when
• The appliance does not • Confirm cooking activation by pressing detect food inside The the button
.
The appliance will activate in manual mode
periodically
+
stop the appliance, remove the mode is automatically
food, close the appliance properly, activated). re-program
the appliance and wait until end of preheating.
• The appliance has been • Disconnect the appliance from
the kept open for too long outlet and leave for 2-3 mins.,
restart while cooking. the process. The next time you use
the
• The appliance has been appliance, make sure you open
and idle too long after the close it quick for best cooking
Solution
results. If end of warm up or keep the problem occurs
again contact your warm. local Tefal customer service.
• Appliance failure.
• Appliance stored or used appliance and immediately
restart a in a room that is too cold. preheat cycle. If the
problem persists, contact your Customer Service.
• Appliance failure. • Unplug the appliance and contact
customer service.
placing again. the food inside.
quantity of food is
insufficient, " OK "
is blinking.
• Disconnect and reconnect your
• Preheating time was cut • Monitor the cooking
The indicator light will
blink red. short.
93