Important Advice; Safety Recommendations - Orbegozo PHE 50 Manual De Instrucciones

PHE 50 PHE 70

IMPORTANT ADVICE

Read the instructions in this manual carefully. It has important information both for
•
operational use and for your safety.
Do not start up faulty apparatus.
•
Maintenance and repairs should be carried out by a qualified technician. If these
•
instructions are not abided by, there is a risk of annulling the guarantee.
This apparatus can be installed and started up by the user following both the fitting
•
instructions as well as the Official Regulations on gas installations. However, if you
want to be quite sure, we would recommend that this task be placed in the expert
hands of an authorized technician.
Keep this instruction manual as it can be useful for reminding you of advice and
•
instructions and for any other user. If it is lost, do not hesitate to ask for another copy
from our Technical Service Network.
For use outdoors and in well ventilated areas. A well ventilated area must have a
•
minimum of 25% of the surface area open.The surface area is the sum of the walls
surface.
Do not obstruct the ventilation holes of the cylinder housing.
•
Do not move the appliance when in operation.
•
Shut off the valve at the gas cylinder or the regulator before moving the appliance.
•
This appliance must be installed and the gas cylinder stored in accordance with the
•
regulation in force.
The tubing or the flexibile hose must be changed within the prescribed intervals.
•
Use only the type of gas and the type of cylinder specified by the manufacturer.
•
In case of violent wind particular attention must be taken against tilting of the
•
appliance.

SAFETY RECOMMENDATIONS

Installation and repair should be done by a qualified service person.
•
Improper installation, adjustment, alteration can cause personal injury or property
•
damage.
Do not attempt to alter the unit in any manner.
•
Never replace or substitute the regulator with any regulator other than the factory-
•
suggested replacement.
Do not store or use gasoline or other flammable vapors or liquids into the heater unit.
•
The whole gas system, hose regulator, pilot or burner should be inspected for leaks or
•
damages before use.
All leak tests should be done with a soap solution. Never use an open flame to check
•
for leaks.
Do not use the heater until all connections have been leak tested.
•
Turn off immediately the gas valve if smell of gas is detected.
•
Do not transport heater while it's operating.
•
Do not move the heater after it has been turned off until the temperature has cooled
•
down.
Keep the ventilation opening of the cylinder enclosure free and clear of debris.
•
Do not paint radiant screen, control panel or top canopy reflector.
•
ENGLISH
12