Orbegozo PHE 50 Manual De Instrucciones página 15

PHE 50 PHE 70
-The heater must be checked with a full cylinder.
-Make sure the safety control valve is in the OFF position.
-Make a soap solution of one part liquid detergent and one part water.The soap solution can
be applied with a spray bottle, brush or rag.
-Soap bubbles will appear in case of a leak.
-Turn the gas supply ON.
-In case of a leak, turn off the gas supply.Tighten any leaking fittings, then turn the gas supply
on and recheck.Contact your dealer for assistance if bubbles continue to appear.
-Never leak test while smoking.
FUEL GAS ODOR
LP gas and natural gas have manmade odorants added specifically for detection of fuel gas
leaks.
If a gas leak occurs you should be able to smell the fuel gas. Since Propane (LP)is heavier than
air you should smell for the gas odor low to the floor. ANY GAS ODOR IS YOUR SIGNAL TO GO
INTO IMMEDIATE ACTION!
-Do not take any action that could ignite the fuel gas. Do not operate any electrical
switches.Do not pull any power supply or extension cords. Do not light matches or any other
source of flame. Do not use your telephone.
-Get everyone out of the building and away from the area immediately.
-Close all propane (LP) gas tank or cylinder fuel supply valves,or the main fuel supply valve
located at the meter if you use natural gas.
-Propane (LP) gas is heavier than air and may settle in low areas. When you have reason to
suspect a propane leak, keep out of all low areas.
-Use your neighbor's phone and call your fuel gas supplier and your fire department. Do not
reenter the buiding or area.
-Stay out of the building and away from the area until declared safe by the firefighters and
your fuel gas supplier.
-FINALLY, let the fuel gas service person and the firefighters check for escaped gas. Have them
air out the building and area before you return. Properly trained service people must repair
any leaks, check for further leakages, and then relight the appliance for you.
OPERATION AND STORAGE
TO TURN ON THE HEATER
1. Turn on the valve on the gas supply cylinder completely.
2. Press and turn the variable control knob to PILOT position (counter-clockwise 90º)
3. Press down the variable control knob and hold for 30 seconds. While holding down the
variable control knob after the pilot flame lights.
Note:
If a new tank has just been connected, please allows at least one minute for the air in the gas
pipeline to purge out through the pilot hole.
When lighting the pilot flame make sure that the variable control knob is continuously pressed
down while pressing the igniter button. Variable control knob can be released after the pilot
flame lights.
Pilot flame can be watched and checked from the small round window with sliding lid located
at the bottom of the flame screen (to the left or right side of the controller).
If the pilot flame does not light or it goes out,REPEAT STEP 3.
4. After the pilot flame lights, turn the variable control knob to minimum position and leave it
there for 5 minutes or more before turning the knob to desired temperature position.
15