Orbegozo PHE 50 Manual De Instrucciones página 13

PHE 50 PHE 70
Control compartment, burner and circulation air passageways of the heater must be
•
kept clean.
Frequent cleaning may be required as necessary.
•
The LP tank should be turned off when the heater is not in use.
•
Check the heater immediately if any of the following exists:
•
- The heater does not reach temperature.
- The burner makes popping noise during use (a slight noise is normal when the
burner is extinguished).
- Smell of gas in conjunction with extreme yellow tipping of the burner flames.
The LP regulator/hose assembly must be located out of pathways where people may
•
trip over it or in area where the hose will not subject to accidental damage.
Any guard or other protective device removed for servicing the heater must be
•
replaced before operating the heater.
Change the gas cylinder in a well ventilated area ,away from any inflammation source.
•
Check that the regulator seal is fitted and that it is in good condition.
•
Do not obstruct the ventilation holes of cylinder housing.
•
Adults and children should stay form high temperature surface to avoid burns or
•
clothing ignition.
Children should be carefully supervised when they are in the area of the heater.
•
Clothing or other flammable materials should not be hung on the heater or placed on
•
or near the heater.
LP Characteristics - Flammable, explosive, heavier than air-settles in low areas.
•
In its natural state, propane has no odor. For your safety, an odorant is added that
•
smells like rotten cabbage.
Contact with liquid LP can cause freeze burns to skin.
•
This heater is shipped from the factory for LP gas use only.
•
Use only EEC approved "20lb." LP gas cylinders (same as commonly used on gas grills)
•
with safety valves.
These valves can be quickly identified by their external and internal threads.
•
Never use a cylinder with a damaged body, valve, collar or foot ring.
•
When heater is not in use, turn Control Valve OFF.
•
Always perform a leak test on gas connections whenever a cylinder is connected (see
•
Page 4). Never use a flame to test for leaks. Do not smoke while performing a leak test.
Note: Flame screen is quick-ware part.
•
WARNING: In order to avoid overheating, do not cover the heater.
•
Caution! The surface remains hot during and after its use
•
The appliance isn't destined for the use of children or person with physical or mental
•
problems and without experience nor knowledge; unless they make it down control of
a responsible or professional for the use of the appliance.
WARNING: In order to ensure your children's safety, please keep all packaging (plastic
•
bags, boxes, polystyrene etc.) out of their reach.
INSTALATION RECOMENDATIONS
It is important the current legal Regulations which lay down the specifications for the fitting
and startup of this apparatus, and so we recommend you consult an authorised
13