EcoFlow 100 W Rigid Solar Panel Manual De Instrucciones página 11

4. Place the solar panel with the z-shaped bracket on the roof in the position for installation, and drill holes on the
roof in the corresponding position of the hole on the pedestal of the z-shaped bracket.
5. Clean the holes and apply adhesive (be sure to apply the structural adhesive around the hole).
7. After matching the pedestal of the z-shaped bracket with the holes in the roof, install the hex self-drilling screw
[5.5*38 mm (0.2*1.5 in), with plastic ring], leave them standing for ≥24 h, and wait for the structural adhesive to
cure [ambient temperature ≤30°C (86°F), humidity ≤70% RH].
8. After the structural adhesive has cured, remove the excessive adhesive on the pedestal and roof. Install more
solar panels and connect them in series or parallel as necessary.
Gluing Area
8