Bolt Installation - EcoFlow 100 W Rigid Solar Panel Manual De Instrucciones

5.4 Bolt Installation

Installation requires the use of a special bolt kit (purchased separately), which includes the following items:
Four z-shaped brackets, four M6 hex bolts (with nuts), four M6 large washers, four M6 flat washers, four M6
spring washers, and eight hex self-drilling screws [5.5*38 mm (0.2*1.5 in)]
Z-shaped
bracket x4
M6 Flat
Washer x4
a. You must use the M6 stainless steel bolt, nut and washer, as well as the mounting hole on the rear side of the
module's frame.
b. Use suitable corrosion-resistant material for fastening, which should be made from stainless steel.
c. Do not drill holes in or modify the module's frame as this will void the warranty.
d. Each module must be securely mounted at four or more points in opposite directions.
e. When installing on the roof or body of a vehicle, be sure to leave a gap between the solar panel and the roof
or body to facilitate airflow and heat dissipation.
The steps are as follows:
1. Use a manual glue gun to apply the structural adhesive to the corresponding area (the surface contacting with
the frame) of the z-shaped bracket.
Gluing Area
Hex Bolt (with Nut) x4
M6 Spring
Washer x4
M6 Large
Washer x4
Hex Self-Drilling
Screw x8
6