Sauder 430877 Instrucciones De Montaje página 9

Step 5
å
Flip the UPRIGHT (F) over.
å
Separate the WIDE EXTENSION SLIDES (18) from the WIDE EXTENSION RAILS (17) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten the WIDE EXTENSION RAILS (17) to the UPRIGHT (F) and RIGHT END (G). Use four 1/2" FLAT
HEAD SCREWS (9).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the UPRIGHT and RIGHT END.
Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
17
Slide the black lever up and pull the SLIDE from the RAIL.
Use this hole
17
430877
18
Open end
1/2" FLAT HEAD SCREW
(4 used in this step)
F
Finished edge
www.sauder.com/service
Open end
9
G
7
Use these holes
17
Use this hole
17
Page 9