3/4" Flat Head Screw - Sauder 430877 Instrucciones De Montaje

Step 3
å
NOTE: Position the parts exactly as shown.
å
Fasten the RIGHT EXTENSION RAIL and SLIDE (16) to the EXTENSION BLOCK (M) and UPRIGHT (F). Use two
3/4" FLAT HEAD SCREWS (10) through the RIGHT EXTENSION RAIL and SLIDE, through the EXTENSION BLOCK,
and into the UPRIGHT.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the UPRIGHT. Turn a SCREW
into this hole.
Closed end
M
Finished edge
430877
6th hole
16
F
www.sauder.com/service
Use these holes
16

3/4" FLAT HEAD SCREW

(2 used in this step)
Bracket must
be positioned
as shown
16
M
10
16
Page 7