Publicidad
Step 6
å
Push two SAUDER TWIST-LOCK® FASTENERS (10F) into the large
holes in the UPRIGHT (Q).
å
Fasten one EXTENSION RAIL (35MA) to the UPRIGHT (Q). Use two
SILVER 1/2" FLAT HEAD SCREWS (128S) through holes #1 and #3.
å
NOTE: For the EXTENSION RAIL, turn a SCREW into the hole shown in
the enlarged diagram. Then, slide the inner cartridge of the EXTENSION
RAIL in to find the other hole that lines up with the hole in the UPRIGHT.
Turn a SCREW into this hole.
Do not tighten the TWIST-LOCK®
FASTENERS in this step.
10F
2
Open end
Page 10
SILVER 1/2" FLAT HEAD SCREW
(2 used for the RAIL)
Q
2
1
This hole
must be here.
426509
2
128S
7
3
Part (Q). Another
sturdier, easier,
friendlier component!
7
www.sauder.com/service
Publicidad
