Publicidad
Hardware Usage Guide
HOW TO USE A TWIST-LOCK
1.
Push a TWIST-LOCK® FASTENER
into the large hole in the part.
Step 1
å
Assemble your unit on a carpeted floor or on the empty
carton to avoid scratching your unit or the floor.
å
To begin assembly, push two SAUDER TWIST-LOCK®
FASTENERS (10F) into the large holes in the RIGHT END (A).
10F
Do not tighten the TWIST-LOCK®
FASTENERS in this step.
www.sauder.com/service
FASTENER
®
Look for this icon. It means a video assembly tip is
available at www.sauder.com/service/tips
Find the numbered video or scan the QR code.
426509
2.
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
Meet Part (A). This component has
been engineered to be lighter, stronger,
faster... well ok. Not technically faster.
But definitely makes for a sturdier
L-Desk that' s easier to assemble and
friendlier to the environment.
A
Dowel end
2
This hole
must be here.
Page 5
Publicidad
