Swash Installation - brondell Swash CL2200 Manual Del Propietário

PRODUCT INSTALLATION

Swash Installation

Please read these instructions carefully before
installing the Swash. Failure to do so could
result in flooding, leaking, or damage to the
product.
NOTE: Steps may vary by type of seat
and toilet
1. Existing toilet seat removal
a. Lift hinge covers and use a screwdriver
to remove the mounting bolts.
b. Remove the toilet seat; keep for future
use.
2. Turn off water supply valve and flush toilet
a. Turn water valve off to stop the flow of
water.
b. Flush toilet and hold down handle to
completely empty tank.
c. Disconnect water supply hose from toilet
tank; do not disconnect from the water
supply valve.
Step 2c
NOTES:
You may wish to place a container under
the tank to catch excess water.
Do not continue without completing the
above steps.
Failure to do so could result in flooding,
leaking, or damage to the Swash.
12
3. Connect the top of the T-valve to the
incoming water connection on the bottom
of your toilet tank
NOTES:
The T-valve connects to the fill valve
directly under your toilet tank—it does
not connect at the wall.
Check to ensure the rubber washer sits
flat inside of the T-valve.
Only connect to the cold toilet water
supply line.
If your water supply line is rigid you may
need to replace the water supply line
before continuing.
4. Connect the water supply line coming from
the wall to the bottom of the T-valve
Steps 3,4
Continued following page