Barazza 1PIDC30N Manual De Instalacion Y Uso página 30

E6
EN
out range (voltage and/or
E7
E8
E9
Temperature sensor error
EA
EH
Temperature sensor stuck
ER03
Continuous key activation
ER20
Power supply voltage is
frequency)
Internal error
Fan failure
for cooking zone
Internal error
for cooking zone
detected
Internal error inside TC
Cooking zone Power supply voltage is
cannot be turned out of range (see tech-
ON nical data for details)
Wrong mains frequency
or mains voltage phase
signal problems
Internal error in genera-
Cooking zones
-
are turned OFF
Corresponding Fan blocked by dust or
cooking zone is
turned OFF
Fan or module electro-
Corresponding Temperature sensor
cooking zone is line for cooking zone is
turned OFF open or short-circuited
Cooking zones
are turned OFF
Flash checksum error
IGBT- Idle current too
Heat sink sensor
broken or shorted
EEPROM- data Error
Coil selection error
Defect inductor or
wrong inductor
MCU internal register
Gate power voltage out
ADC startup test failure
ADC bandgap voltage
Capacitor Control
wrong signal Defect
hardware device
Corresponding Not enough temperatu-
cooking zone is re change after switch
turned OFF
No temperature change
(min. 10 K / 5 min)
after cooking zone is
Cooktop switches Water or cookware pla-
off after 10 sec. ced on TC's SmartKiis
Cooktop switches
off
30
Contact technical
Contact technical
Contact technical
tor's circuitry
Contact technical
Clean and remove
fabrics foreign bodies
Contact technical
nics defective
Contact technical
- Contact technical
Contact technical
Contact technical
high
Contact technical
Contact technical
2. Contact technical
Contact technical
setting
Contact technical
of range
Contact technical
invalid
Contact technical
Cool down the glass
on the hob
Contact technical
energized
Remove water or
cookware from the
- Contact technical
support.
support.
support.
support.
support.
support.
support.
support.
support.
support.
support.
1. Re-plug
support.
support.
support.
support.
support.
support.
glass
support.