Hella Gutmann Radaufnehmer Control Instrucciones De Operación página 24

3. | Working with the Wheel Clamp Module Control
Wheel clamp module SE / wheel clamp module WA (line laser):
7. Carefully tighten the set screw of the scale.
8. Switch off the laser beam of the wheel clamp module 1st GEN / wheel clamp module SE / wheel clamp module
WA.
9. Attach the wheel clamp module Control to the front right wheel.
NOTICE
Pay attention that the level gauge bubble of the wheel clamp module Control is centered.
CAUTION!
Laser radiation
Damage to/destruction of the retina
Never look directly into the laser beam.
10. Switch on the laser beam of the wheel clamp module 1st GEN / wheel clamp module SE / wheel clamp module
WA (see operating instructions of the CSC-Tool).
11. Align the laser module by turning the mounting bolt on the scale of the wheel clamp module Control.
The laser beam is indicated on the scale of the wheel clamp module Control.
Wheel clamp module 1st GEN (dot laser):
Wheel clamp module SE / wheel clamp module WA (line laser):
24
Hella Gutmann
Radaufnehmer Control