Using Your Induction Hob - universalblue UBE2400-20 Manual De Instrucciones

4.

USING YOUR INDUCTION HOB

4.1. TO START COOKING
1. Touch the ON/OFF control. After power on, the
buzzer beeps once, all displays show " – " or " – –
", indicating that the induction hob has entered
the state of standby mode.
2. Place a suitable pan on the cooking zone that you
wish to use. Make sure the bottom of the pan and
the surface Of the cooking zone are clean and
dry.
3. Touching the heating zone selection control ,and a indicator next to the key will
flash
4. Select a heat setting by touching the "-" or "+" control.
 If you don't choose a heat setting within 1 minute, the
Induction hob will automatically switch off. You will need
to start again at step 1.
 You can modify the heat setting at any time during
cooking.
If the display flashes
This means that:
 you have not placed a pan on the correct cooking zone or,
 the pan you're using is not suitable for induction cooking or,
 the pan is too small or not properly centred on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
4.2. WHEN YOU HAVE FINISHED COOKING
1. Touching the heating zone selection control that you wish to switch off.
alternately with the heat setting
37