Before Locating The Fixing Brackets; Adjusting The Bracket Position - universalblue UBE2400-20 Manual De Instrucciones

 The work surface is square and level, and no structural members interfere with
space requirements.
 The work surface is made of a heat-resistant material.
 If the hob is installed above an oven, the oven has a built-in cooling fan.
 The installation will comply with all clearance requirements and applicable
standards and regulations.
 A suitable isolating switch providing full disconnection from the mains power
supply is incorporated in the permanent wiring, mounted and positioned to comply
with the local wiring rules and regulations.
 The isolating switch must be of an approved type and provide a 3 mm air gap
contact separation in all poles (or in all active [phase] conductors if the local wiring
rules allow for this variation of the requirements)
 The isolating switch will be easily accessible to the customer with the hob installed
 You consult local building authorities and by-laws if in doubt regarding installation
 You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the
wall surfaces surrounding the hob.
When you have installed the hob, make sure that
 The power supply cable is not accessible through cupboard doors or drawers
 There is adequate flow of fresh air from outside the cabinetry to the base of the hob
 If the hob is installed above a drawer or cupboard space, a thermal protection
barrier is installed below the base of the hob
 The isolating switch is easily accessible by the customer

BEFORE LOCATING THE FIXING BRACKETS

The unit should be placed on a stable, smooth surface (use the packaging). Do not
apply force onto the controls protruding from the hob.

ADJUSTING THE BRACKET POSITION

Fix the hob on the work surface by screw 2 brackets on the bottom of hob(see picture)
after installation.
Adjust the bracket position to suit for different table top thickness.
A B C
Screw Bracket Screw hole
D
base
51