Technical Data - EINHELL TE-TC 920 UL Manual De Instrucciones

back.
•
Damage to hearing if the ear-muffs specified
are not used.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Motor rating ...............S1 800 W / S6 20% 900 W
Motor speed ......................................... 2950 rpm
AC motor ................................ 220-240 V ~ 50 Hz
Protection class ................................................. I
Protection type ............................................. IP54
Cut length .............................................. 920 mm
Jolly length .............................................. 920 mm
Max. workpiece thickness 90° .................. 36 mm
Max. workpiece thickness 45° .................. 29 mm
Table size ...................................... 890 x 475 mm
Working height: ...................................... 700 mm
Diamond wheel ........................... Ø 200 x Ø 25.4
Weight (without cutting wheel and
with an empty water container) .... approx. 43.5 kg
Max. operating weight
(with cutting wheel and a
fi lled water container) ...................... approx. 85 kg
Max. weight/dimensions
of the workpiece ....................56 kg / 92 x 60.5 cm
Operating mode S6 20%: Continuous operation
with idling (cycle time 10 minutes). To ensure that
the motor does not become excessively hot, it
may only be operated for 20% of the cycle at the
specifi ed rating and must then be allowed to idle
for 80% of the cycle.
Danger! Sound and vibration
The noise emission values were measured in ac-
cordance with EN 62841-1.
With-load operation
L sound pressure level ........................ 72 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level .......................... 85 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
GB
The quoted total vibration value and the
quoted noise emission value were measured in
accordance with standardized test procedures
and can be used to compare one electric tool with
another.
The quoted total vibration value and the quoted
noise emission value can also be used to make
an initial assessment of exposure.
Warning!
•
The vibration and noise emission levels
during actual use may vary from the values
quoted, depending on the way in which the
electric tool is used and, in particular, on the
type of workpiece being processed.
•
For the operator's protection it is essential
to specify safety measures based on an
estimate of the exposure to vibrations during
the actual conditions of use (all stages of the
operating cycle must be considered in this
connection, e.g. times in which the electric
tool is OFF and times in which the tool is ON
but operating without load).
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
- 23 -