Checking Battery Level - DJI T40 Guía De Usuario

• Make sure the battery is placed on a flat surface to avoid damage to the battery from sharp
objects.
• DO NOT place anything on a battery. Otherwise, the battery may be damaged, which may lead
to fire hazards.
• The battery is heavy. Be careful when moving the battery to avoid dropping it. If the battery
is dropped and damaged, immediately leave the battery in an open area away from people.
Wait 30 minutes and soak the battery in water for 24 hours. After making sure the power has
completely run out, dispose of the battery in accordance with local laws.
• Make sure the battery is fully charged before each flight.
• Immediately land the aircraft if a critical battery level warning appears and replace with a
fully charged battery.
• Before operating in a low-temperature environment, make sure the battery is at least above
5° C (41° F). Ideally, above 20° C (68° F).
LED Patterns
The Battery Level Indicators will show the current battery level and status during charging and
discharging. The indicators are defined below:
LED is on
LED is off

Checking Battery Level

If the battery is in power saving mode, press the power button once to check the current battery level.
LED1 LED2
LED Patterns During Charging
During charging, the LEDs blink in sequence to indicate the current battery level. All the LEDs will be off
after a full charge. Disconnect the battery when charging is complete, and always use the officially
recommended charging device to charge the battery.
LED1 LED2
LED is blinking
LED3 LED4
LED3 LED4
Battery Level
88%~100%
75%~87%
63%~74%
50%~62%
38%~49%
25%~37%
13%~24%
0%~12%
Battery Level
0%~49%
50%~74%
75%~89%
90%~99%
100%
5