Kinderkraft I-GUARD Manual De Instrucciones página 48

5.0 Height of headrest and shoulder straps
To adjust the height of the headrest, proceed as follows:
• At the same time, while holding down the 5-point harness adjustment button (4), loosen
the harness to allow for more freedom in adjusting the height of the headrest.
• Hold the head restraint adjustment lever (13) which is located at the back of the headrest.
If you want to raise the headrest, pull the handle gently upwards. Adjust the headrest to the
desired height. When the height has been adjusted, release the adjusting handle, and the
headrest will be locked in the selected position.
• The height of the headrest can be lowered by pressing the height adjustment lever (13).
When the height has been adjusted, release the adjusting handle, and the headrest will be
locked in the selected position.
Adjust the height of the shoulder straps so that the strap enters the seat back flat, horizontally
just above the child's shoulders. Make sure that the shoulder straps are correctly adjusted to
the child's shoulders according to (fig. B.1).
NOTE: If necessary, repeat the adjustment of the headrest height until the shoulder straps are
adjusted to the optimal height. Make sure that the harness is not twisted.
5.1 Rotating mechanism
• The rotation mechanism is a function which helps to position the child in the seat or to
remove it in a comfortable way. Correct positioning of the seat in the direction of travel (fig.
A.14):
a) from 40 to 105 cm rearward-facing,
b) from 76 to 105 cm forward-facing.
• Turn the seat with the seat rotation lever (7), this function allows you to easily position and
remove the child from the seat. Turn the seat, place the child in the seat, secure the child with
the 5-point harness, and perform the rotation of the seat according to the above
recommendation for each cm group. Verify that the rotation function is correctly locked. For
this purpose check the colour of the indicator near the seat rotation lever (7) - the green
colour confirms that the seat rotation function is locked (Fig. A.9).
5.2 Backrest adjustment / Backrest tilt adjustment
• The angle of the seat can be adjusted (fig. A.4) using the lever (6) under the seat. Pull the
lever and move the seat. Release the lever at the desired position. Move the seat slightly until
you hear a distinct clicking sound - the seat is now secured in the chosen position.
NOTE: Between 40 and 105 cm with the seat rearward-facing, use position '1', the most
reclined position of the seat (fig. B.2a). Between 76 and 105 cm with the seat installed
forward-facing, you can use the full range of backrest recline adjustment in positions '1' to '4'
(fig. B.2b).
48