Speed Specification - Mafell FM 1650 PV-LO Traducción Del Manual De Instrucciones Original

Legend:
Unit
HS
U
AC
U
PV
PS
S
U
S
U
O
GND
n
N/A
When the PV interface is not in use, protect it against dirt with the supplied covering cap Z (Fig. 3).
5.2.1 Assignment portal connector
All pins on the portal connector are protected against reverse polarity. At voltages above 30 V, continuous
operation with reversed polarity must be avoided as this can lead to failure of the PV interface.
Pin No.
1
2
3
4
Order No. 208311

5.3 Speed specification

With the setting wheel X (Fig. 2) you can adjust the speed continuously. The concrete speed values of individual
stages can be found in the table on page 5 or on the speed sticker on the housing.
Until the motor characteristic is reached, the built-in electronics readjust to the set speed.
Meaning
= power switch
= mains voltage
= power supply (PV interface)
= position setting wheel
= control voltage speed (PV interface)
= display remaining runtime in overload mode (PV interface)
= reference potential for voltages of the PV interface
= speed of the working spindle
= not applicable or not relevant
Colour
Parameter
wire
Order
208311
U Brown
PV
U White
S
U Black
O
GND Blue
of
No.
-32-