Setting / Adjustment; Mains Connection; Selection Of Tools - Mafell FM 1650 PV-LO Traducción Del Manual De Instrucciones Original

- Avoid sharp bends in the cable. Do not wind the cable around the milling motor especially when transporting
and storing the milling motor.
- The use of the power tool with water or conductive liquids is prohibited.
- The milling motor must not be used as a hand-held milling motor.
- Keep the milling motor away from rain or moisture. The penetration of water into the milling motor increases
the risk of electric shock.
- Encased portals must have a sufficient dust/chip extraction. The concentration of dust in the air can create an
explosive mixture!
Do not use:
- Damaged tools or tools that have changed their shape.
- Blunt tools due to the excessive motor load.
- Tools that are not suitable for the milling motor speed during idling.
Instructions on the use of personal protective equipment:
- Always wear ear protectors during work.
- Always where a dust mark during work.
- Always wear protective goggles during work.
Instructions on operation:
- Do not reach with your hands into the danger zone of the tool.
- Examine the workpiece for foreign objects.
- Monitor the speed. If an uncontrolled speed increase or speed jump occurs, the power supply must be
switched off immediately.
Instructions on service and maintenance:
- Regular cleaning of the milling motor is an important safety factor.
- Only original MAFELL spare parts and accessories may be used. Otherwise, the manufacturer will not accept
any warranty claims and cannot be held liable.
4

Setting / Adjustment

4.1 Mains connection

Prior to initial operation, make sure that the mains voltage agrees with the operating voltage stated on the milling
motor's rating plate.

4.2 Selection of tools

Only use the collets listed in the chapter "Optional accessories". Tools are selected depending on the materials
to be processed and the capacity of the feed drives. Do take the maximum permissible tool diameters and the
maximum permissible material-specific material removal rates into account. The material removal rate Q of
material-removing machining processes describes the volume of chips removed within a specific time.
-27-