Installation; Baby-Unit - Alecto DVM-75 Manual Del Usuario

3 INSTALLATION

3.1 BABY-UNIT:

Power:
1. Connect one of the supplied 6V
power adaptors to the 6V DC
input of the baby unit.
2. Insert the adapter into a 230V
wall socket.
Only use the supplied power adaptor
with model number S005BNV0600060.
cable ties available specifically for this purpose.
Wall-mounting:
Drill two holes next to each
other in the wall, separated by a
distance of 5.7cm and
insert plugs and screws. The
head of the screw should
stick out of the wall for several
millimeters.
Slide the foot of the baby unit over the screws and then
press the baby unit a little downwards.
Tips for placement:
• For use as a baby monitor: place the baby unit at
least 2 meters away from your baby and make sure to
safely tuck away the adapter cable.
• For optimal range, it is advisable to set up the baby unit
as high as possible, free from large metal surfaces.
• The temperature protrudes from the rear of the baby
unit. Make sure this sensor hangs freely, unexposed to
direct sunlight and avoid heat from e.g. light bulbs.
• The baby unit is not waterproof. When using outdoors,
make sure to protect the baby unit against moisture
>2m
When used as a baby
monitor: Make sure the
baby cannot reach the
baby unit or wire. Place
the baby unit at least
2 meters away from
the baby and you can
bundle cables that are
too long with tape or
7