Se Of The Machine For Purposes For Which It Is Intended; Ncorrect Use; P Rior To Taking The Machine Into; T Aking The Machine Into Service - SUHNER ABRASIVE LWA 70-KF Documentación Técnica

1. N
1.1 g
enerAl notes on sAfety
This operation manual is applicable for the machine LWA
70-KF.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The tool is designed for grinding, metal, stone, and plastic
with grinding tools.
1.3 i

ncorrect use

All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner GmbH, Trottäcker 50, D-79713 Bad Säckin-
gen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side) com-
plies with the requirements under the Directive 2006/42/
EG. Applied standards: EN ISO 12100, EN ISO 11148.
Document Agent: T. Fischer. D-Bad Säckingen, 10/2019.
T. Fischer/Managing Division manager
2. C
2.1 P
rior to tAKing the mAchine into serVice
Use oiled compressed air (see also air
quality under section 2.3). Observe nation-
al regulations.
2.1.1 m
ount the suPPly hose
Screw connection nipple into the valve body, invert suply
hose through connection nipple and fix it with hose clamp
(available as an accessory).
16
S
oTES oN aFETy
ommISSIoNINg
2.2 t
AKing the mAchine into serVice
Before connecting the tool to the com-
pressed air supply set the sleeve to the
«OFF» position! The tool may be switched
on only when the attachment have been installed correct-
ly.
2.2.1 t /t
urn on urn off
Turning on the machine by moving the sleeve in the ar-
row direction. Off by moving the sleeve in the opposite
direction.
Before cutting off the compressed air supply, al-
ways set the machine to the «OFF» position so
that the tool cannot be reactivated inadvertently.
2.2.2 s
etting the Air direction
The side air direction can be adjusted by turning the
sleeve.
2.3 r

Ating dAtA

Pressure
Power output
Air consumption full load
Air consumption at idling
Setting oiler idle
No-load speed
Max. wheel diameter
Sound pressure level EN ISO 15744 78dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight with hose
max. 6.3bar
75W
0.22m /min
3
0.24m /min
3
about 1 drops/min
70000min
-1
19-22mm
1.6m/s , K=1.24m/s
2 2
2/4/4
0.180kg