Klein Tools 501-915 Manual De Instrucciones página 7

Measuring Length to Short Faults (Category, Twisted Pair, Data Cable)
1. While measuring a twisted pair cable, if there is a short between twisted pin
pairs (i.e. a short between wires 1-2, 3-6, 4-5 or 7-8), the tester will display
"SHORT", with the distance to the short location.
2. If there is a short between two even numbered wires (i.e. a short between
wires 2, 4, 6, or 8), the tester will display "SHORT", but distance cannot be
measured
3. If there is a short between two odd numbered wires (i.e. a short between wires
1, 3, 5, or 7), the tester cannot detect a short
4. If there is a short between an even and an odd numbered wire that is not a
twisted pin pair (for example, a short between wires 1 and 4), the tester will
display "SHORT", and the distance to the short location for the even wire only
Measuring Two Conductor and Other Cable
1. Connect the BNC-to-Alligator Clips
test cable to the BNC port on
13
the top of the Cable length Meter.
2. The cable to be measured should
have a pair of exposed conductors
that run side-by-side (this includes
inner pairs on twisted pair cable).
The opposite end of the cable
to be tested should be left open
(unconnected).
3. Securely attach the alligator clips
to the two exposed conductors of
the cable to be tested.
4. Press the Power button
power-ON the meter.
5. Use the Up
11
Arrow buttons to highlight "Other"
and press the "Select" button (three dots)
appear on the screen. NOTE: If the cable you are measuring is not in the library,
refer to the Changing VoP Value / Adding New Cable Information section.
6. Use the "Library" button (three dots)
manufacturer or style with the correct VoP. The VoP value is displayed on the
screen in the top description. NOTE: If the cable you are measuring is not in
the library, refer to the section on calculating VoP.
7. Press the Test Button
the "Test Lead Subtraction" when using the included test leads.
8. To edit Library entries, use the Up
highlight the desired selection and press the "Edit" button (two dots)
enter the cable information screen. Again, use the Up
buttons to highlight the desired field and press the "Edit" button (two dots)
. Use the "Left Arrow" (one dot)
to move the cursor to the desired location and then use the Up
Arrow buttons to select the desired character. Press the Save button
12
to save the change or press the "Cancel" button (two dots)
changes. Use the Up
fields or press the back button (one dot)
OPERATING INSTRUCTIONS
to
5
and Down
12
to measure the length of the cable. NOTE: Turn ON
9
and Down
11
05/29/2020
Length:
Type
. The default cable choice will
8
to select a different cable
8
and Down
11
and "Right Arrow" (three dots)
6
Arrow buttons to select additional
12
to return to the Library.
6
07:30
CAT4UT
CAT5ST
1.23 ft
Library
Arrow buttons to
12
and Down
11
11
to discard
7
55%
VOP
VOP
68.3%
68.3%
Home
to
7
Arrow
12
7
buttons
8
and Down
10
7