Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
6. To edit Library entries, use the Up
highlight the desired selection and press the "Edit" button (two dots)
to enter the cable information screen. Again, use the Up
Arrow buttons to highlight the desired field and press the "Edit"
12
button (two dots)
Arrow" (three dots)
location and then use the Up
the desired character. Press the Save button
press the "Cancel" button (two dots)
Up
and Down
11
the "Go Back" button (one dot)
Measuring Twisted Pair (Category,
Twisted Pair, Data) Cable
1. The cable to be measured must
be terminated with an RJ45
plug on the end that will be
attached to the Cable Length
Meter. The opposite end of the
cable to be tested should be
left unterminated, or may be
terminated with an RJ45 plug
or jack, but left unconnected.
2. Insert the RJ45 plug into the
RJ45 port
2
Length Meter.
3. Press the Power button
power-ON the meter.
4. Use the Up
11
Arrow buttons to highlight the Data Cable option and press the "Select"
button (three dots)
the screen.
5. Press the "Library" button (three dots)
manufacturers and styles. Use the Up
buttons to highlight the desired selection, and press the "Select"
button (three dots)
in the library, refer to the Changing VoP Value / Adding New Cable
Information section.
6. To edit Library entries, use the Up
highlight the desired selection and press the "Edit" button (two dots)
to enter the cable information screen. Again, use the Up
Arrow buttons to highlight the desired field and press the "Edit"
12
button (two dots)
Arrow" (three dots)
location, then use the Up
the desired character. Press the Save button
press the "Cancel" button (two dots)
Up
and Down
11
the "Go Back" button (one dot)
7. Press the Test Button
ON the "Test Lead Subtraction" when using the included test leads.
6
OPERATING INSTRUCTIONS
. Use the "Left Arrow" (one dot)
7
buttons to move the cursor to the desired
8
Arrow buttons to select additional fields or press
12
in the Cable
to
5
and Down
12
. The default Data cable choice will appear on
8
. NOTE: If the cable you are measuring is not
8
. Use the "Left Arrow" (one dot)
7
buttons to move the cursor to the desired
8
and Down
11
Arrow buttons to select additional fields or press
12
to measure the length of the cable. NOTE: Turn
9
and Down
11
and Down
11
12
to discard changes. Use the
7
to return to the Library.
6
05/29/2020
Pair 1-2
Pair 3-6
Pair 4-5
Pair 7-8
Type
to display stored cable
8
and Down
11
and Down
11
Arrow buttons to select
12
to discard changes. Use the
7
to return to the Library.
6
Arrow buttons to
12
and Down
11
and "Right
6
Arrow buttons to select
to save the change or
10
07:30
CAT4UT
Library
Arrow
12
Arrow buttons to
12
and Down
11
and "Right
6
to save the change or
10
7
55%
VOP
68.3%
0.0 ft
0.0 ft
0.0 ft
0.0 ft
Home
7
Publicidad
Tabla de contenido
