Tabla de contenido
Publicidad
6.
Clean the area around the oil filter. Place a container under the
filter to catch any oil and remove the filter. See Figure 24.
Oil Filter
7.
Place the new filter in an open pan with the open side facing up.
Fill with new oil until the oil reached the bottom of the threads.
Wait two minutes for the oil to be absorbed by the filter material.
8.
Apply a thin film of clean oil to the rubber gasket on the filter.
9.
Carefully install the new filter.
10. Refill the engine with the recommended oil and check the oil
level; refer to Checking and Adding Oil in the Assembly Section.
11. Reinstall the oil filler cap/dipstick securely.
12. Reconnect spark plug wire.
Air Cleaner and Pre-Cleaner
Pre-Cleaner
1.
Open the air cleaner access door and unhook the latch. See
Figure 25.
Air Cleaner
Latch
Pre-Cleaner
SERVICE AND MAINTENANCE
Figure 24
Figure 25
2.
Remove the pre-cleaner.
3.
Replace or wash the pre-cleaner in warm water with detergent.
Rinse thoroughly and allow the pre-cleaner to air dry.
4.
Hook the latch and close the access door.
Air Cleaner
1.
Open the air cleaner access door and unhook the latch. See
Figure 25.
2.
Remove the air cleaner and pre-cleaner from the base.
3.
Service the pre-cleaner as instructed above.
4.
Install the new or serviced pre-cleaner over the new air cleaner
and install on the base.
5.
Hook the latch and close the access door.
Spark Plug
DO NOT check for a spark with the spark plug removed. DO NOT
crank the engine with the spark plug removed.
If the engine has been running, the muffler will be very hot. Be careful
not to touch the muffler.
The spark plug should be checked every 25 hours and changed once
a season or every 100 hours. To ensure proper engine operation, the
spark plug must also be properly gapped and free of deposits.
1.
Remove the spark plug boot and use a spark plug wrench to
remove the plug, Figure 26.
Spark
Plug Boot
Access
Door
2.
Visually inspect the spark plug. Discard the spark plug if there is
any apparent wear, or if the insulator is cracked or chipped. Clean
the spark plug with a wire brush if it is to be reused.
25
WARNING
WARNING
Spark Plug
Figure 26
Publicidad
Tabla de contenido
Solución de problemas
