Parti Sostitutive; Manutenzione E Pulizia - Surewerx JACKSON Translight Plus 555 Instrucciones De Uso

Ocultar thumbs

página de 26

/ 26
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Setti ng the grind Mode: There are two modes of operation that can be selected: welding or grinding.

By selecting the Grind mode, the fi lter switches off and it will not be triggered by the sparks generated

during grinding. The grind mode can be selected in two ways on the external button or by pressing the

GRIND button on the inside of the helmet .To set the ADF to grind mode externally press the centre

Grind button located externally on fi ne tune adjustment knob the side of the welding helmet. When the

ADF grind mode tit is indicated on the left hand display showing a shaded triangle next to the mode. To

return to the welding mode press the grind button again either internally of externally. Before restarting

welding work, the ADF should be set back to the »Weld« position.

Replacement of batteries:

1 Place the helmet face down. Tilt the headgear unit the sweatband is closer to the top of the

helmet. Now undo the thumb screw turning it anti-clockwise (Fig. 1), remove the thumb screw

and put to one side.

Lift the retainer frame upwards until it is at an angle of roughly 45 degrees (Fig 2). The gen-tly

pull the frame towards the chin of the helmet this will release the hooks (Fig. 3).

3 To release the ADF from the cradle simply push the ADF out whilst holding the retainer (push

from viewing side but not on the glass)

4 The battery trays are located on the bottom of the ADF below the solar panel (Fig 4) using your fi

ngernail pull the trays out (the tray will depict the polarity showing which side is + and which side

is negative.

Once the batteries have been replaced please follow steps in reverse for refi tting

RECOMMENDED SHADE LEVELS FOR VARIOUS WELDING APPLICATION S /

Troubleshooting

●

Irregular Darkening Dimming

Headgear has been set unevenly and there is an uneven distance from the eyes to the fi lter lens (Reset the

headgear to reduce the difference to the fi lter)

●

Auto-Darkening fi lter does not darken or fl ickers

1 Front cover lens is soiled or damaged (Change the cover lens).

Sensors are soiled (Clean the sensors surface).

Translight 555 User Manual.indd 7-8

GB 4

Usando un cacciavite negativo piccolo, separare il disco rotante con un movimento di lieve attor-

cigliamento. Togliere le 2 viti positive dall'interno del casco e spingere il pulsante "Grind" dall'ester-

no del casco, verso dentro. Fig 11, 12)

Per rilasciare l'ADF dal proprio vano, spingere semplicemente l'ADF in fuori, mentre si mantiene

l'elemento di trattenimento (spingere dal lato di visuale, ma non sul vetro)

Installare l'ADF sostitutivo seguendo le fasi in ordine opposto. I comandi dovranno essere infi lati

attraverso la fessura apposita verso l'esterno del casco e quindi alloggiati nella fessura stessa. Il

cavo elettrico va premuto con cautela sul lato del casco, in modo che non sia di intralcio.